The defaults for logs and functions are set in the tab "options".
- Logging – In this group,
the settings for logging for network calculation are made.
- Fatal – Serious errors
which lead to the abortion of network calculation. This kind of error is always
logged.
- Error – Error during
network calculation (e.g., exceeding/falling below limit values, errors in
configuration data). This kind of error is always logged.
- Warning – Warnings about
possible errors (e.g., warnings about nodes with only one attached pipe).
- Information – Most
important information on the execution of network calculation (e.g., number of
iteration steps with hydraulic calculation, display of the most important
indexing steps during network calculation).
- Topology – Messages about
dead "branches" and "dead ends" in the network are given if this field is
marked.
- Function – Activated tasks
for the calculation can be switched on and off using the option switches.
- Update Drawings – If this
field is marked, then sisHYD automatically creates a set of network sketches
with the new calculation result.
- Network sketches are
always based on a design template. sisHYD determines the created network
sketches and associated templates from the latest result. The new results are
applied to the templates thus found.
- Start Design Result Wizard
– Starts the assistant to update the pipes pipe classes with the results of the
dimensioning, after a successful design calculation.
